Fully Automatic Stainless Steel Temperature Humidity Test Chamber For Electronic Products

● GB-2423．1-2008 (IEC68-2-1) Test A: Low Temperature Test

● GB-2423．2-2008(IEC68-2-2) Test B: High Temperature Test

● GJB360．8-2009(MIL-STD．202F) High Temperature Operating Life Test

● GBJl50．3-2009(MIL-STD-810D) High Temperature Test

● GJBl50．4-2009(MIL-STD-810D) Low Temperature Test

※KOMEG Programmable KM-5166 LCD Touch Screen Controller with PID control parameters setting

※Flexible approach for data collection and recording

※Key Parts are imported to ensure the service life and high reliability;

※ Efficient oil separator to ensure the compressor life.

Ⅴ. Body Structure

Interior size

External Size

External material

Interior material

Insulation material

Floor load bearing

Door

Threading hole

Lighting Device

Heating

Compressor

Refrigerant

Condenser

Evaporator

other attachments

Expansion system

Refrigerant flow control

Refrigeration process

※ Full implementation of nitrogen protection welding, two-stage rotary vane pump vacuum, to ensure that the refrigeration system internal clean,reliable;

※ The bottom of the compressor design water tray, the condensate through the rear of the tank drain to the box outside the box.

1. Sensor

KOMEG Programmable KM-5166 LCD Touch Screen Controller with PID control parameters setting

Temperature and humidity settings (SV) Practical (PV) value can be displayed directly;

Execution of the program can display numbers, paragraphs, remaining time and cycles, running time display,

Program editing and graphic curve display,

Fixed or program operation status display,

Resolution: 800*480, 7-inch TFT display screen.

5.Display

Resolution

Temperature conditions:–100～200 ℃；

Temperature can be adjusted based on the working temp. range of the equipment (the upper limit: +5℃, the lower limit : -5℃)

Humidity conditions:0～100 %RH.

Set the running time to reach 9999 h 59 m(Set 0 to constant operation without time limit)；

Available program capacity: Up to 1000 groups；

The memory capacity that can be used: Each group of 1000 times (step)；

Repeated commands: Each command can be up to 999 cycles.

Data collection and curve display when connected to a computer

Can be used as monitoring and remote control system

Multiple machines synchronization control available

RS-232,RS-485 and Ethernet.

RAM with battery protection, setting(SV), Practical(PV) and sampling time can be saved;

The curve recording period can be set 10～60 sec. Maximum historical data memory storage is 90 days, historical data(When sampling).

a. Emergency stop switch

b. switch

c. Over-temperature protector

d.RS-485 interface

a. Leakage switch;

b. Heater burnout protection switch;

c. Circulating fan over current overload protection;

d. Compressor overpressure protection;

e. Compressor motor overheating protection;

f. Compressor motor over-current protection;

g. Overvoltage owe anti-phase protection

h. Breaker

1.Power